Posted on

Specialist bespoke metal fabrication requires specialist bespoke silicone rubber mouldings

Bespoke rubber mouldings for masking and other applications in low volume  fabrications.

There are thousands of companies producing low volume metal fabrications for specialist applications in vehicles. This isn’t just specific to motor vehicles either. The UK is not only a leading exported of motor vehicles but also aerospace, defence, shipping and other modes of transport. Trains are also produced in the UK.

The UK has always been famous for pioneering design and bespoke solutions. Whether its military conversions on vehicles, emergency vehicles or any other short production run such as motorsport, the UK is world renowned for design and bespoke manufacturing.

For manufacturers and sub contractors, the processes on short production runs can be very similar to large volume production. The main difference being that the big robotic production lines aren’t often used in low volume manufacturing, but that in its self is why the UK is so different. There are thousands of small engineering firms across the UK producing bespoke assemblies for defence, aerospace, motorsport and specialist vehicles.

By the very nature of bespoke and limited run, masking can also take on a need for bespoke applications. AFAC has over the years produced a wide variety of custom silicone rubber mouldings for these niche industries.

Case study of bespoke silicone rubber mouldings for low volume metal fabrication work

For one customer, when the military were still using Land Rovers as a principle vehicle, they were installing a radio rack into the rear of the vehicle. It was a simple design of a plate with oval holes reamed out of it to allow adjustment of the radio.

The problem was that the bolts and washers used to fix the radio to the plate were also the earthing points. As a result, an area around each oval hole needed masking to allow for the movement that had been built into the design.

Using the BAKEWELL Silicone Rubber TUGPLUG as a basis for the design, we created an oval section and then added a “washer” into the design with a sealing lip around the edge for quality of finish. The first design was prototyped and worked perfectly.

Tooling is relatively inexpensive and the production run was only a matter of a few hundred items.

The Outcome

Satisfied customer and problem solved.

Working on limited volume fabrications and have a need for custom rubber mouldings or extrusions? Get in touch right now on 0845 094 0522

Posted on

Solving customer problems with bespoke design and production of silicone rubber mouldings.

The Problem

When one of our customers, manufacturing parts for a military vehicle, had a masking problem, they called on A.F.A.C.’s technical team to help them out. The problem they had was with a bracket that supported military radio equipment. Continue reading Solving customer problems with bespoke design and production of silicone rubber mouldings.